Sony RS-232C Interface Manual page 36

LINE 4 INPUT : 43[H] 49[H] 4D[H] 34[H] ('CIL4')
This command is used to implement setting up the LINE 4 input channel.
Various setups can be memorized in the scene memories by specifying these scene Nos.
• Packet format
43[H] 49[H] 4D[H] 34[H] "parameter" 0D[H]
• Parameter
The parameter consists of the 64 bytes all the time in the order as shown in the table below.
byte Parameter name
1st SCENE No.
2nd-9th LINE4 A INDEX
10th-17th LINE4 B INDEX
18th-25th LINE4 C INDEX
26th-33rd LINE4 D INDEX
34th-41st LINE4 E INDEX
42nd-49th LINE4 F INDEX
50th LINE4 A TRIM
51st LINE4 B TRIM
52nd LINE4 C TRIM
53rd LINE4 D TRIM
When you specify NONE (30[H] '0') as the scene No. in the 1st byte, you can establish the present setup.
At the same time, when you specify the scene No.(31[H] ('1') through 44[H] ('D')), parameters of the subsequent 2nd through 64th bytes
are written in the scene memory.
The method of setting the scene No. and index of LINE4A through F, is the same as that of the GROUP FADER command. See pages 29
and 30.
Method of setting the LINE4A-F TRIM, FUNCTION ON/OFF, PEQ1,2 frequency, PEQ1,2 Q, PEQ1,2 Gain, Gain Limit level and input
fader level is the same as that of the LINE 3 INPUT command. See pages 32 to 35.
For the packet example, see the example of the LINE 3 INPUT command on page 35. However, the parameter length becomes 64 bytes.
LINE 4 INPUT PARAMETER REQUEST : 52[H] 49[H] 4D[H] 34[H] ('RIL4')
This command is used to read setup of the LINE 4 input channel from the SRP-X700P.
• Packet format
52[H] 49[H] 4D[H] 34[H] "parameter" 0D[H]
• Parameter
Specify the scene No. of the scene memory that you want to read, as the parameter.
Method of specifying the scene No. is the same as that of the GROUP FADER command. See page 29.
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] ('A')) in the
order shown below.
41[H] "parameter" 0D[H]
The parameter is the same as the 63 bytes of the LINE4 INPUT command parameter from which the scene No. is exempted.
byte Parameter name
54th LINE4 E TRIM
55th LINE4 F TRIM
56th FUNCTION ON/OFF
57th PEQ1 Frequency
58th PEQ1 Q
59th PEQ1 GAIN
60st PEQ2 Frequency
61st PEQ2 Q
62nd PEQ2 GAIN
63rd GAIN LIMIT LEVEL
64th FADER LEVEL
– 36 –