Sony RS-232C Interface Manual page 45

When you specify the scene No.(31[H] ('1') through 44[H] ('D')), parameters of the subsequent 2nd through 8th bytes are written in the
scene memory.
• Scene No. (1st byte)
This command is used to specify the scene No.
SCENE No.
1 31[H] ( '1' )
2 32[H] ( '2' )
3 33[H] ( '3' )
4 34[H] ( '4' )
5 35[H] ( '5' )
6 36[H] ( '6' )
7 37[H] ( '7' )
8 38[H] ( '8' )
9 39[H] ( '9' )
10 3A[H] ( ':' )
• MIC MUTING (2nd byte)
This command is used to specify muting of the MIC input channels with the 8-bit data.
When you want to set the MUTING status, set the corresponding bit to 1. When you want to cancel MUTING, set the corresponding bit
to 0.
Bit-6 and bit-7 are fixed all the time.
bit7 bit6
0 1
• LINE MUTING (3rd byte)
This command is used to specify muting of the LINE input channels with the 8-bit data.
When you want to set the MUTING status, set the corresponding bit to 1. When you want to cancel MUTING, set the corresponding bit
to 0.
Bit-2 to bit-7 are fixed all the time.
bit7 bit6
0 1
• LINE OUTPUT1-6 MUTING (4th byte)
This command is used to specify muting of the LINE OUTPUT1 to 6 channels with the 8-bit data.
When you want to set the MUTING status, set the corresponding bit to 1. When you want to cancel MUTING, set the corresponding bit
to 0.
Bit-6 and bit-7 are fixed all the time.
bit7 bit6
0 1
• LINE OUTPUT7,8/REC OUT1,2 /SPEAKER OUTPUT1,2 MUTING (5th byte)
This command is used to specify muting of the LINE OUTPUT7,8, REC OUT1,2, SPEAKER OUTPUT1 and 2 with the 8-bit data.
When you want to set the MUTING status, set the corresponding bit to 1. When you want to cancel MUTING, set the corresponding bit
to 0.
Bit-6 and bit-7 are fixed all the time.
bit7 bit6
0 1
SCENE No.
11
12
13
14
15
16
17
18
19
20
bit5 bit4 bit3
MIC6/ MIC5/ MIC4
LINE2 LINE1
bit5 bit4 bit3
0 0 0
bit5 bit4 bit3
OUT6 OUT5 OUT4
bit5 bit4 bit3
SPEAKER SPEAKER REC
OUTPUT2 OUTPUT1 OUT2
3B[H] ( ';' )
3C[H] ( '<' )
3D[H] ( '=' )
3E[H] ( '>' )
3F[H] ( '?' )
40[H] ( '@' )
41[H] ( 'A' )
42[H] ( 'B' )
43[H] ( 'C' )
44[H] ( 'D' )
bit2 bit1
MIC3 MIC2/
WL2
bit2 bit1
0 LINE4
bit2 bit1
OUT3 OUT2
bit2 bit1
REC OUTPUT8 OUTPUT7
OUT1
– 45 –
bit0
MIC1/
WL1
bit0
LINE3
bit0
OUT1
bit0