Terbly LPAR7QZ User Manual page 20

9.6.2. Calibrat
1 Access the main menu.
2 Press <Up/Down>, the display will show"Adjust".
3 Press< ENTER>, the display will show"Adjust".
4 The display show"Calibrat".
5 Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
9.7. EditProg
1 Tap <MODE/ESC> button access the main menu Tap the <Up/Down> button until
"Edit grogram" is displayed. Press ENTER, the display will show "Edit grogram".
2 The display show "Select programs", Press <Up/Down>, the display will show "Edit
Program", " Edit Scenes" , "Rec. Controller".
3 Press <ENTER> to confirm or press <MODE/ESC> to return to the main menu.
Run the auto program A master fixture can output to three different program signals to
the slave fixture to operate. It means the host will send cyclically in the following orders
(The host will keep operating the program of Part 1) Then the slave fixture will make
the selectively receiving according to its own set.
1 If the slave fixture chooses Run For Slave 1 from the menu of 1-3,then it will receive
the part 1's automatic program from link, in the same way, when the slave fixture
chooses Run For Slave 2,then it will receive the part 2's automatic program from link.
Enter the menu of 1-3 Function Mode---Set To Slave, Here to set machine operate
2
which part of the program during the host-slave connection
3 Enter the menu of 1-4,1-5 Function Mode---Set To Master
4 Enter the menu of 8-1 Edit Program---Auto Program Part1.The host outputs three
groups driven program---Part1, Part2, Part3(Part1 program runs the same effect as the
host)
5 Enter the menu of 8-2 Edit Program---Edit Program. Edit the program's connection,
connect the scene in order
6 The editor of the scene, there are as many as 250 scenario editors, and every scene can
have a program connection of 10.
Note:
Part 2, Part 3 repeat in accordance with the Part1's repeat. For example: When Part 1
uses Program 2, Part 2 uses Program 4, Part 3 uses Program 6, Assume: Program 2
includes scene of 10, 11, 12, 13; Program 4 includes scene of 8, 9, 10; Program 6
includes scene of 12, 13, 14, 15; Then it will run as below.
Example
LPAR7QZ User Manual
19
XM1334-V1.2-B