Alarm Processing; Overview - Siemens SIMATIC ET 200S Function Manual

Alarm processing

6.1

Overview

Sequence of the alarm processing
Pending error messages are processed and evaluated differently than in a SIMATIC system.
Diagnostic alarms are not enabled by default. Activate the alarms for the relevant module in
the hardware configuration (refer to Chapter Inserting the ET 200S frequency converter into
a SIMOTION project (Page 11)).
If you have parameterized diagnostic alarms, then you should program the alarm processing
sequence according to the principle presented below.
Figure 6-1
Additional references
A detailed description of the system functions can be found in the
Variable Devices Parameter Manual. This document is shipped with SIMOTION SCOUT in
electronic form.
Supplement for the ET 200S frequency converter
Function Manual, 01/2015
Alarm processing for the frequency converter
6
SIMOTION System Function/
33