Calculation in the converter:
4)
Note
You can find the normalizing value in the
Parameter Manual (03/2005 Edition) under parameter p2000.
The execute parameter is only used to start acyclic data transfer from/to the frequency
converter.
When the frequency converter is switched on, the enables must be set in the control word and
the setpoint (setpoint) takes immediate effect.
The effect of the control word depends on the parameterization in the frequency converter.
Bit assignment of ctrlDword (control words 1 and 2 for the ET 200S FC):
5)
Supplement for the ET 200S frequency converter
Function Manual, 01/2015
4.1 Function block _ET200S_FC_control
SIMATIC ET 200S FC Frequency Converter
Parameterization
19