Installation - ADJ FOCUS BEAM LED User Instructions

Focus Beam LED
NOTICE: When installing the unit, the trussing or area of installation must be able to hold 10 times
the weight without any deformation. The suitable enviromental temperature for this lighting fixture is
between -25˚ C to 45˚ C. Do not place this lighting fixture in an enviroment where the temperatures
are under or above the temperatures stated above. This will allow the fixture to run at its best and
help prolong the fixture life. Be sure this fixture is kept at least 12m (40ft) away from any flammable
materials (decoration etc.).
SAFETY CABLE
RIGGING POINT
OMEGA BRACKET
ATTACHMENT POINTS
Screw one clamp each via a M12 screw and nut into the Omega bracket. Insert the quick-lock fasteners
of the Omega holder's into the respective holes on the bottom of the Focus Beam LED. Tighten the
quick-lock fasteners fully clockwise. Always use and install the supplied safety cable as a safety
measure to prevent accidental damage and/or injury in the event the clamp fails. Pull the safety
cable through the openings located on the base plate and over the trussing system or a safe fixation
spot. Insert the end in the carabine and tighten the safety screw. Note: Never use the carrying handles
for secondary attachment.
ADJ Products, LLC - www.adj.com - Focus Beam LED User Manual Page 8

Installation