ADJ FOCUS BEAM LED User Instructions page 21

Focus Beam LED
DMX SETTINGS - The submenus listed under DMX SETTINGS are as follows: Set Address, DMX
Channel Mode, and No DMX Status.
- SET ADDRESS - In this submenu you can find and set your desired DMX address.
- DMX CHANNEL MODE - In this submenu you can find and set your desired DMX channel mode.
- NO DMX STATUS - This submenu setting is used as a precaution mode in case the DMX signal is
lost or interrupted. The operating mode chosen in this submenu is the running mode the fixture
will go into when the DMX signal is lost. Listed below are the 3 modes.
• Hold Last - This setting will have the fixture stay in the last DMX setup.
• Blackout - This setting will have the fixture automatically go into stand by mode.
• Manual - This setting will go into the current manual control set up. See MANUAL CONTROL.
PERSONALITY - The submenus listed under PERSONALITY are as follows: Status Settings, Fan
Settings, Dim Modes, LED Refresh Rate, Gamma, Reset Motors, Display, and Service.
- STATUS SETTINGS - In this submenu you are able to access and adjust/change: Pan Invert, Tilt
Invert, P./T. Feedback, P./T. Speed, and Hibernation.
- FAN SETTINGS - In this submenu you are able to select your desired fan speed setting.
- DIM MODES - In this submenu you are able to select your desired dimmer mode and adjust the
dimming speed time.
- LED REFRESH RATE - In this submenu you are able to select your desired LED refresh rate.
- GAMMA - In this submenu you are able to select your desired gamma setting.
- RESET MOTORS - In this submenu you are able to reset selected motors.
- DISPLAY - In this submenu you you are able to adjust the display intensity, invert the display, activate
the display blackout, and activate/deactivate the display lock.
- SERVICE - In this submenu you are able to access and adjust/change: the calibration (effect
adjust), activate the service port, update software, and restore the factory settings.
MANUAL CONTROL - This menu is for manual testing and manual control. Pan, tilt, color wheel,
gobo wheel, prism 1, prism 1 rotation, shutter, dimmer, focus, frost can all be tested/adjusted.
NOTE: The Prism and Frost features CANNOT be used at the same time.
INTERNAL PROGRAMS - In this menu you are able to select 1 of 7 internal programs to run. Program
running speed and fade speed are adjustable.
ADJ Products, LLC - www.adj.com - Focus Beam LED User Manual Page 20
System Menu