THORLABS ITC8000 Operation Manual page 4

6.3.6 Selecting Constant Current or Constant Power Mode
6.3.7 Selecting the Type of the Temperature Sensor
6.3.8 Thermistor Calibration
6.3.9 Temperature Window
6.3.10 Setting the P, I and D Share of the Control Loop
6.4 Switching ON and OFF
6.5 Error Messages
7 Communication with a PC
7.1 Nomenclature
7.2 Data Format
7.3 Commands and Queries
7.3.1 Select the Module Slot (SLOT)
7.3.2 Query Type of Module (TYPE)
7.3.3 Selecting the Photo Diode Polarity (PDPOL)
7.3.4 Selecting the Operation Mode (MODE)
7.3.5 Programming the BIAS Voltage (VBIAS)
7.3.6 Selecting the Laser Diode Polarity (LDPOL)
7.3.7 Reading the Laser Diode Hardware Limit (LIMCP)
7.3.8 Programming the Laser Diode Software Limit (LIMC)
7.3.9 Setting the Laser Diode Current (ILD)
7.3.10 Setting the Monitor Diode Current (IMD)
7.3.11 Calibrating a Photodiode (CALPD)
7.3.12 Programming the Optical Power (POPT)
7.3.13 Activating the Temperature Protection (TP)
7.3.14 Switching the Laser Output On and Off (LASER)
7.3.15 Reading the Laser Diode Voltage (VLD)
7.3.16 Programming the TEC Current Software Limit (LIMT)
7.3.17 Programming the Temperature (TEMP)
7.3.18 Programming the Temperature Window (TWIN)
7.3.19 Programming the Resistance Window (RWIN)
7.3.20 Selecting the Sensor (SENS)
7.3.21 Programming the Resistance of the Temperature Sensor (RESI)
7.3.22 Thermistor Calibration - Exponential Method
7.3.23 Thermistor Calibration - Steinhart-Hart Method
7.3.24 Programming the PID Shares (SHAREP, SHAREI, SHARED)
7.3.25 Switching the I Share On / Off (INTEG)
7.3.26 Switching the TEC On / Off (TEC)
7.3.27 Reading the TEC Current (ITE)
7.3.28 Reading the TEC Voltage (VTE)
7.4 IEEE Error Messages
7.5 Status Reporting
7.5.1 Standard Event Status Register (ESR)
30
30
30
32
32
32
34
36
36
36
37
37
37
37
37
38
38
39
39
40
41
42
42
43
43
44
44
45
46
46
47
47
48
49
50
50
51
51
52
53
55
58