Table of Contents
Advertisement
6. Pick-up drive belt:
a. The idler pulley should be
positioned so the pick-up
drive belt does not slip when
operating.
b. Loosen idler pulley anchor
bolt and tap pulley into its
new required position.
c. Tighten anchor bolt to its
specified toque.
7. Always check and maintain
pulley alignment. Lay a straight
edge across the pulley faces
to check the alignment. Adjust
alignment if pulley faces vary
more than 1/32 inch (.7 mm).
WARNING
Machine is shown with guard
removed for illustrative purposes
only. Do not operate machine
with guard removed.
Fig. IDLER PULLEY
Advertisement
Table of Contents
