Initial Startup And Operation; Commissioning; Pre-Commissioning Checks; Inspection Before Each Commissioning - Interroll ZoneControl Operating Manual

6

Initial startup and operation

6.1

Commissioning

Pre-commissioning checks

Ensure that the ZoneControl has been correctly fastened to the profile and that all screws have been correctly
¾
tightened.
Ensure that there are no additional areas of danger caused by interfaces to other components.
¾
Ensure that the wiring is in accordance with the specification and legal directives.
¾
Check all protection devices.
¾
Ensure that no personnel stand in hazardous areas near the conveyor.
¾

Inspection before each commissioning

Check the ZoneControl for visible damage.
¾
Check the DIP switch settings (see „DIP switches", page 21).
¾
Check all protection devices.
¾
Clearly specify and monitor the way goods are placed on the conveyor.
¾
Ensure that the RollerDrive is not blocked.
¾
Ensure that no personnel stand in hazardous areas near the conveyor.
¾
6.2

Operation

Caution
Accidental start-up of the RollerDrive!
Danger of crushing of limbs and damage to goods!
Ensure that no unauthorised persons are near the conveyor before switching on the operating voltage.
¾
The ZoneControl is initialised after the operating voltage has been applied. The ZoneControl is then brought into a
defined basic state and packages that are not within the detection range of a sensor are transported onto the next
zone sensor. The RollerDrives in unoccupied zones rotate and RollerDrives in occupied zones do not rotate. The start
and end zones are automatically detected if they are wired correctly. Initialisation mode takes 4 seconds. During the
initialisation mode the zone sensor can be assigned as often as required.
Version 2.0 (04/2019) Online
Translation of the original operating manual
Initial startup and operation
39 von 54