Using Voice Recognition (Unit With Voice Recognition Only) - ENHANCED VISION Merlin Plus User Manual

Using Voice Recognition
(Unit with voice recognition only)
Using Voice Recognition
• To change magnification size, simply say "bigger" or "smaller." Repeat as
needed to reach the size you desire, pausing between commands to allow
Merlin Plus to complete each movement.
Merlin Plus is programmed to switch between sizes 1 (minimal), 4, 7, 10,
13 and 16 (maximum) on your command. For example, if you are at level 2
and say "bigger", Merlin Plus will increase to level 4.
• To change viewing mode, simply say "change" and Merlin Plus will
change to the next viewing mode option. Repeat the word until you come to
the viewing mode you desire.
Tips for Using Voice Recognition
• Merlin Plus has been trained to respond to your voice at its normal volume
when facing the microphone on the control panel.
• If there is any background noise, such as a radio or television, Merlin Plus
may not respond because it is not able to distinguish your voice from the
other sounds. Reduce the background noise and try again.
• If you want to make more than one move between magnification levels or
choices of visual mode, pause between commands to allow Merlin Plus to
complete each move separately.
• The level set with the SIZE dial overrides sizes arrived at by verbal
commands. For example, if the SIZE dial is set to size 8 and then you
verbally command Merlin Plus to go to a smaller size, the next time you turn
the SIZE dial to increase size it will immediately go to size 9, and increase
further from that level.
36