Table of Contents
Advertisement
Chapter 4 - Operation and Administration
4.2.5.3.4
Display CIR/MIR Info
Displays information on the MIR/CIR and some other parameter for associated
Subscriber Units:
CIR TX: The Downlink CIR configured in a VL SU. Always 0 for SU-EZ.
MIR TX: For all SU-EZ units this is the value of MIR: Downlink for SU-EZ.
CIR RX: The Downlink CIR configured in a VL SU. Always 0 for SU-EZ.
MIR RX: Uplink MIR configured in the SU.
CIR Delay: This is the configured value of the Maximum Delay parameter in
the SU.
SU Name: Not Available for SU-EZ.
Ver: NA for SU-EZ.
Type: The Unit Type of the SU.
IP: The IP address of the SU.
4.2.5.3.5
Gateways Table
When the DRAP option is supported, the Gateways Table provides details on the
active Gateways connected to any of the SUs served by the AU. For each Gateway,
the displayed information includes:
Gateway Type (VG-1D1V, VG-1D2V, NG-4D1W)
IP Address
Number of Voice Calls (applicable only to Voice Gateways)
4.2.5.4
Continuous Noise Floor Display
The Continuous Noise Floor Display option displays continuously updated
information regarding the average noise floor in the wireless link. It also displays
continuously updated information about the Signal Interference Ratio. Signal
Interference Ratio (SIR) is the average SNR for all pulses and physical errors
received by the unit. The average has the same formula used for calculation of
SNR per CPE.
BreezeACCESS EZ AU-EZ
65
Menus and Parameters
System Manual
Advertisement
Table of Contents
