Table of Contents
Advertisement
Chapter 3 - Commissioning
Parameter
DFS Detection Algorithm
ATPC Option for EZ
Transmit Power
Tx Control
Antenna Gain
Maximum Distance
VLAN ID-Management
Authentication Algorithm
Data Encryption Option
Security Mode
Default Multicast Key
Key 1 to Key 4
NOTE
Some parameters are changed to their new values only after reset (refer to
details). After the basic parameters are configured, the unit should be reset in order to activate the
new configuration.
3.1.2
Country Code Selection
CAUTION
The selected Country Code must comply with applicable local radio regulations.
BreezeACCESS EZ AU-EZ
Table 3-1: AU-EZ Basic Parameters
Default Value
ETSI
Disable
Dependent on
Country Code
On
According to the
antenna supplied
with the unit and the
Country Code.
0 (No Compensation)
65535
Open System
Disable
WEP
Key 1
00......0 (32 zeros,
meaning no key)
27
Configuring Basic Parameters
Comment
Applicable only for Universal
Country Code in 5.4 or 5.8 GHz
band if DFS is enabled
In ATPC Parameters
If set to "Not Set Yet", must be
configured according to actual
value, taking into account cable's
attenuation.
In Cell Distance Parameters
In VLAN Support
In Security Parameters.
Availability of security parameters
depends on support according to
the country code.
Appendix E
for more
System Manual
Advertisement
Table of Contents
