Table of Contents
Advertisement
Chapter 4 - Operation and Administration
4.1
Working with the Monitor Program
4.1.1
Accessing the Monitor Program Using Telnet
1
Connect a PC to the Ethernet port, using a crossed cable.
Configure the PC's IP parameters to enable connectivity with the unit. The
2
default IP address is 10.0.0.1.
Run the Telnet program. The Select Access Level menu is displayed.
3
Select the required access level, depending on your specific access rights. A
4
password entry request is displayed.
each of the access levels.
Access Rights
Read-Only
Installer
Administrator
NOTE
Following three unsuccessful login attempts (using incorrect passwords), the monitor program is
blocked for several minutes. To enable access to the monitor program during that time, the unit
must be reset via SNMP or by disconnecting/reconnecting power.
If you forgot the password, type "h" at the Access Level selection prompt. Type "Recover" at the
prompt to get a challenge string consisting of 8 characters. Contact Alvarions Customer Service and
give them the challenge string (after user identification) to receive a one-time password. After
entering this password at the prompt, the unit will reboot with the default Administrator password
(private). Three consecutive errors in entering the one-time password will invalidate it and block the
monitor program. A new challenge string should be used to receive a new one-time password.
Enter your password and press Enter. The Main Menu is displayed as shown
5
in
Figure
BreezeACCESS EZ AU-EZ
Table 4-1: Default Passwords
4-1. The unit type (AU-EZ) and location (if configured), SW version
Working with the Monitor Program
Table 4-1
lists the default passwords for
Password
public
user
private
33
System Manual
Advertisement
Table of Contents
