Figure 2-4: The Waterproof Seal; Connecting The Indoor-To-Outdoor Cable - Alvarion BreezeACCESS EZ AU-EZ System Manual

Chapter 2 - Installation
2.3.4

Connecting the Indoor-to-Outdoor Cable

To connect the indoor-to-outdoor cable:
Unscrew the top nut from the waterproof seal.
1
Route a straight Category 5E Ethernet cable (8-wire, 24 AWG) through both
2
the top nut and the waterproof seal.
NOTE
Use only Category 5E 4x2x24# FTP outdoor cables from an approved manufacturer. See list of
approved cables and length limitations in
3 Insert and crimp the RJ-45 connector. Refer to
preparing the cable.
4 Connect the Ethernet cable to the outdoor unit RJ-45 connector.
Verify that the o-ring supplied with the waterproof seal is in place. Attach the
5
waterproof seal to the unit, and then tighten the top nut. Make sure that the
external jack of the cable is well inside the waterproof seal to guarantee a good
seal.
6 Route the cable to the location selected for the indoor equipment.
Assemble an RJ-45 connector with a protective cover on the indoor end of the
7
indoor-to-outdoor cable.
BreezeACCESS EZ AU-EZ

Figure 2-4: The Waterproof Seal

Section 2.1.2
21
Installing the Outdoor Unit
.
Appendix D for instructions on
System Manual