Table of Contents
Advertisement
Chapter 4 - Operation and Administration
Refer to
4.2.3.5
Flash Memory Control
The Flash Memory Control submenu enables selecting the active software version
for the unit.
The flash memory can store two software versions. One version is called Main and
the other is called Shadow. New software versions are loaded as the shadow
version. You can select the shadow version as the new active version by selecting
Reset and Boot from Shadow Version. However, after the next reset, the main
version is re-activated. To continue using the currently active version after the
next reset, select Use Running Version After Reset: The previous shadow
version will be the new main version, and vice versa.
The parameters configured in the unit are not changed as a result of loading new
software versions unless the new version includes additional parameters or
additional changes in the list of parameters. New parameters are loaded with their
default values.
Select from the following options:
Reset and Boot from Shadow Version: Activates the shadow (backup) software
version. The unit is reset automatically. Following the next reset the unit will
switch to the main version.
Use Running Version After Reset: Defines the current running version as the
new main version. This version will also be used following the next reset.
4.2.3.6
Log Out Timer
The Log Out Timer parameter determines the amount of inactive time following
which the unit automatically exits the Monitor program.
The time out duration can range from 1 to 999 minutes.
The default value is 5 minutes.
4.2.3.7
Ethernet Negotiation Mode
The Ethernet Negotiation Mode submenu displays the current Ethernet port state
and enables defining the negotiation mode of the Ethernet port. The available
options are:
Force 10 Mbps and Half-Duplex
BreezeACCESS EZ AU-EZ
Section 4.1
for a list of the default passwords for each of the access levels.
46
Menus and Parameters
System Manual
Advertisement
Table of Contents
