Table of Contents
Advertisement
Chapter 4 - Operation and Administration
Set Partial Factory Defaults
Set Complete Operator Defaults
Set Partial Operator Defaults
Cancel Current Pending Request
4.2.3.2.1.1
Set Complete Factory Defaults
Select this option to reset the unit to the standard Factory Defaults configuration,
excluding several parameters that are listed in
Table 4-2: Parameters that are not changed after Set Complete Factory/Operator
Parameters Group
Unit Control Parameters
Air Interface Parameters
Country Code Parameters
NOTE
The FTP parameters are not set to their default values after Set Complete Operator Defaults.
However, they are set to their default value after Set Complete Factory Defaults. Note that in this
case they are set to the default values immediately upon selecting the Set Complete Factory
Default option (even before the next reset).
4.2.3.2.1.2
Set Partial Factory Defaults
Select this option to reset the unit to the standard Factory Default configuration,
excluding the parameters that are required to maintain connectivity and
management access. The parameters that do not change after Set Partial Factory
Defaults are listed in
BreezeACCESS EZ AU-EZ
Defaults
Parameter
All Passwords
FTP Server IP address* (see note below)
FTP Gateway IP address* (see note below)
FTP User Name* (see note below)
FTP Password* (see note below)
Ethernet Port Negotiation Mode
Frequency
DFS Required by Regulations
Frequency Subset
Antenna Gain
Selected Country Code
Table
4-3.
43
Menus and Parameters
Table
4-2.
System Manual
Advertisement
Table of Contents
