Nibe SMO 40 Installer Manual page 36

Control module
Hide thumbs Also See for SMO 40:
Table of Contents

Advertisement

BASIC VALUES FOR THE CURVE SETTING
The values stated on the map apply for the "heating
curve" in menu 1.9.1
• The first value applies for low temperature* radiator
systems. "temperature" (offset heating curve) in menu
1.1 must be set to -2.
• The value in brackets refers to under floor heating
systems** installed in concrete floor structures.
• When the system is installed in a timber floor structure
you can use the number before the brackets, but this
value must be reduced by two units. "temperature"
(offset heating curve) in menu 1.1, set in these cases
to -1.
Caution
The map's values are usually a good starting
point and are intended to produce a room
temperature of approximately 20 °C. The values
can be adjusted later if necessary.
Examples of basic values selection:
• House with low temperature* radiator systems
London = Area 15 (8).
Set 15 in menu 1.9.1, "heating curve" and -2 in menu
1.1 "temperature" (offset of heating curve).
• House with under floor heating** installed in a con-
crete floor structure
London = Area 15 (8).
Set 8 in menu 1.9.1, "heating curve" and -2 in menu
1.1 "temperature" (offset of heating curve).
• Houses with under floor heating** installed in a timber
floor structure
London = Area 15 (8).
Set 13 (see point three in the list above) in menu 1.9.1,
"heating curve" and -1 in menu 1.1 "temperature" (off-
set of heating curve).
Caution
An increase in the room temperature can be
slowed by the thermostats for the radiators or
under floor heating. Therefore, open the ther-
mostat valves fully, except in those rooms
where a cooler temperature is required, e.g.
bedrooms.
* A low temperature radiator system means a system where the
supply temperature needs to be 55 °C on the coldest day.
** Underfloor heating can be dimensioned in many different ways.
The above example refers to a system where the supply temperature
needs to be approximately 35 – 40 °C or 45 – 50 °C on the coldest
day.
36
Chapter 6 | Commissioning and adjusting
Aberdeen
Edinburgh
Glasgow
15 (7)
Londonderry
15 (8)
Belfast
Liverpool
Dublin
Limerick
Cork
Plymouth
15 (8)
15 (7)
14 (7)
15 (7)
15 (7)
Manchester
Birmingham
London
15 (8)
Bristol
NIBE SMO 40

Advertisement

Table of Contents
loading

Table of Contents