Nibe SMO 40 Installer Manual

Outline principle
Application
Buildings with water-borne heating sys-
tems.
Alternative
☑
Hot water
☐
VPA
☑
VPB
☐
HWC
☐
VVC with AXC
☐
Additional water heater
☐
Additional heat in tank
Additional heating before QN10
☐
Step controlled electrical addition
☐
Oil, gas, or pellet boiler
Additional heat after QN10
☐
Step controlled electrical addition with
3 pipe UKV
☐
Step controlled electrical addition with
2 pipe UKV (volume increase)
☐
Shunt controlled addition (Oil, gas or
pellet boiler) with 2-pipe UKV
☐
Oil, gas, or pellet boiler
☐
Oil, gas, pellets or wood boiler with hot
water heating
Accessories
☐
Extra climate system
☐
Pool
Reset alternative
NOTE! This is an outline diagram. Actual
installation must be engineered according
to current standards.
NOTE! NIBE does not supply all compo-
nents in this outline diagram.
See the appropriate "Installer manual"/"In-
stallation and Maintenance Instructions" for
more information.
SMO 40 with heat pump, hot water, additional heat and accessory (liquid condensation).
-AA25
-AA25 -AA25
-BT1 -BT50
-EB101
-EB101
-BT12
-BT3
NIBE AB - Energy Systems Box 14, 285 21 Markaryd Tel 0433 - 73 000 Fax 0433 - 73 190 www.nibe.se
-AA25-QN10
-QM31
-GP12
-HQ1
-QM43
-QM32
-QM1
-AA25
-BT25
-BT71
-RN10
-FL2
-CM1
-CP10
-AA25-BT7
-AA25-BT6
Designations according to standard IEC 81346-1 and 81346-2.
ODM GB 1417-1
M11566
PAGE 1 (6)