1734-8Cfgdlx; 1738-8Cfgdlxm23; Modes Of Usage; Standard Point I/O Module - Rockwell Automation Allen-Bradley POINT I/O DeviceLogix User Manual

Table of Contents

Introduction

Publication 1734-UM015A-EN-E - November 2009

1734-8CFGDLX

This module is an 8-point 24V DC I/O module with 8 self-configuring points

and DeviceLogix capabilities. Each of the I/O points can be either a DC input

or output. The module supports removal and insertion under power,

auto-address, and auto-baud in compliance with the POINTBus backplane.

1738-8CFGDLXM8, 1738-8CFGDLXM12, and 1738-8CFGDLXM23

The ArmorPOINT I/O family consists of modular I/O modules. The sealed

IP67 housing of these modules requires no enclosure. Note that

environmental requirements other than IP67 may require an additional

appropriate housing. I/O connectors are sealed M8 (pico), M12 (micro) or

M23 styles. The mounting base ships with the module.

The module can be used in one of the following modes:

• as a standard POINT I/O module,

• in a stand alone DeviceLogix program where it controls its own I/O,

and

• in network applications with or without the peer exchange of data.

The module can simply be used as an 8-point configurable POINT I/O

module. It uses ODVA pre-defined Produce and Consume assemblies. Default

settings help to facilitate quick setup right out-of-the-box. It is CIP network

independent and it can run on DeviceNet, EtherNet/IP or ControlNet when

used in conjunction with an adapter.

Table of Contents