Advantech PCA-6143P User Manual page 82

40 preparation for virtual mode test started.
Going to verify from video memory.
41 Returned after verifying from display memory.
Going to prepare the descriptor tables.
42 Descriptor tables prepared.
Going to enter in virtual mode for memory test.
43 Entered in the virtual mode.
Going to enable interrupts for diagnostics mode.
44 Interrupts enabled (if diagnostics switch is on).
Going to initialize data to check memory wrap around at
0:0.
45 Data initialized.
Going to check for memory wrap around at 0:0 and find the
total system memory size.
46 Memory wraparound test done. Memory size calc. over.
About to go for writing patterns to test memory.
47 Pattern to be tested written in extended memory.
Going to write patterns in base 640 K memory.
48 Patterns written in base memory.
Going to find out amount of memory below 1 M.
49 Amount of memory below 1 M found and verified.
Going to find out amount of memory above 1 M
4A Amount of memory above 1 M found and verified.
Going for BIOS ROM data area check
4B BIOS ROM data area check over.
Going to check ESC and to clear memory below 1 M for soft
reset.
4C Memory below 1 M cleared. (SOFT RESET)
Going to clear memory above 1 M.
4D Memory above 1 M cleared. (SOFT RESET)
Going to save the memory size.
4E Memory test started. (NO SOFT RESET)
About to display the first 64 K memory test.
4F Memory size display stared. This will be updated during
Going for sequential and random memory test.
50 Memory test below 1 M complete.
Going to adjust memory size for relocation/shadow.
51 Memory size adjusted due to relocation/shadow.
Memory test above 1 M to follow.
82 PCA-6143P User's Manual
memory test.