Advantech PCA-6143P User Manual page 12

Warning! Disconnect all power from the chassis before you
Caution! The electronic components on this CPU card are
Install your CPU card as follows:
1. Remove power from the chassis and disconnect all power
cords. Follow all power-down procedures outlined in your
chassis user's manual.
2. Remove the chassis cover, then detach the card hold-down
bracket. This bracket stretches across the top of each circuit
card to hold it securely in place.
3. Locate a free slot in the chassis. You can use any 16-bit (double
connector) slot. We suggest that you leave the maximum
amount of space between boards to improve cooling.
4. You may need to remove a block-off cover at the end of the
slot. Unscrew the cover and save the screw for use in Step 6.
5. Align the card square with the card-end guide slot and parallel
to the connector. Slide the card carefully into the connector.
6. Make sure the card is completely seated in the connector.
Screw the card I/O bracket to the case.
After you have installed the CPU card, you will need to attach the
connecting cables as described in the following chapter. Replace
the card hold-down bracket you removed in Step 2, replace the
chassis cover and power-up your system.
Dimensions for SBC (Single Board Computer) installation appear
in Chapter 1 (page 10).
12 PCA-6143P User's Manual
install the CPU card. Unplug the power cord from
the wall, don't just turn off the power switch. If
you are not sure what to do, take the job to an
experienced professional.
very sensitive to static electric charges. Use a
grounding wrist strap to remove all static electrici-
ty before you touch any components. Place all
components on a static-dissipative mat or in a
static-shielded bag when they are not in the
chassis.