Lcd Voltages And Backlight Control Signals Connector - Seco CCOMe-C30 User Manual

LVDS External EDID Flash Socket
Pin Signal Pin
1 +3.3V_S
2 +3.3V_S
3 +3.3V_S
4 GND
3.3.13

LCD Voltages and backlight control signals connector

On-board there is also a small connector intended for carrying out power supplies, for the connection to an eventual panel backlight's module. This connector carries
out both LCD voltages and backlight control signals.
LCD Voltages and backlight control signals
connector - CN25
Pin Signal Pin
1 VDD_LVDS 2
3 +5V_S 4
5 LVDS_VDD_EN 6
7 Analogic_Dimming 8
9 GND 10
JP6 position LVDS_BKLT_CTRL Voltage Level
Inserted +5V_S
Not Inserted +3.3V_S
JP8 position LVDS_BKLT_EN Voltage Level
Inserted +5V_S
Not Inserted +3.3V_S
CCOMe-C30
CCOMe-C30 - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by F.B. Copyright © 2019 SECO S.p.A.
On the carrier board is also embedded an 8-pin Flash Socket, type LOTES p/n ASPI0001-
CN35
P001A, for the mounting of I2C EEPROMs in SO-8 format, which can be used to store LVDS
DDC Data (to be used when it is not possible directly the DDC Channel
Signal
available on connector CN34).
5 +3.3V_S
6 +3.3V_S
7 LVDS_I2C_CLK
8 LVDS_I2C_DAT
The connector, CN25, is an IDC connector, dual row, 10 pin, p2.54 mm connector,
type MOLEX p/n 70246-1004 or equivalent.
Mating connector: MOLEX p/n 22-25-2102 with 70058 series female crimp terminals.
Signal
LVDS_VDD_EN and LVDS_BKLT_EN are respectively the LCD panel's and the
VDD_BKLT
Backlight's Enabled signals, controlled by the COM Express Modules directly.
+12V_S
LVDS_BKLT_CTRL is the PWM signal that can be used to manage the brightness of the LCD Panel,
LVDS_BKLT_EN and is controlled by the COM Express Modules directly.
LVDS_BKLT_CTRL
Analogic_Dimming is a +5V signal, derived from the PWM signal LVDS_BKLT_CTRL, for direct
analogic control of backlights not supporting PWM.
GND
Backlight PWM Control signal, i.e. s4ignal LVDS_BKLT_CTRL, can also be regulated to be at +5V_S
or +3.3V_S voltage level, using jumper JP6.
Similarly, backlight enable signal, LVDS_BKLT_EN, can be regulated to be at +5V_S or +3.3V_S voltage
level, using jumper JP8.
43