Advertisement
TECHNICAL INFORMATION:
Rated Power:
Heating Element:
Reflector:
Dimensions:
Warm-up time:
Useful wavelength range:
Weight:
Warranty:
Protection:
ELECTRICAL EQUIPMENT:
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist.
IMPORTANT NOTICE TO PURCHASER:
Before utilizing the product, you should determine the suitability of the product for its intended use.
ECOSTRAD expressly disclaims the implied warranties and conditions of merchantability and fitness for a
particular purpose. In no case shall ECOSTRAD LTD be liable under any legal theory, including but not limited to
contract or strict liability, for any direct, indirect special, incidental or consequential damages resulting from product
use.
The product complies with Safety Standards EN60335-2-30, RoHS and EMC EN 50336 and EN 62233. These
cover the essential requirements of EEC Directives 2006/42/EC, 2011/65/EC and 2004/108/EC.
Original instructions covering TUSCANY 2500R produced 042017 onwards.
Ecostrad Tuscany
Ceiling or Wall-mounted Infrared
INSTALLATION & OPERATING INSTRUCTIONS
2500W at 230V
Ultra long life Carbon heating lamp (10,000 hours)
Mirror Aluminium (98% reflection preventing rearward heat loss)
879 x 195.3 x 84.7 mm
5-10 seconds
2 - 5µm
3kg
2 Years (excludes lamp)
IP55
Heater
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ecostrad Tuscany EsS-HC-25
Summary of Contents for Ecostrad Tuscany EsS-HC-25
-
Page 1: Technical Information
ECOSTRAD expressly disclaims the implied warranties and conditions of merchantability and fitness for a particular purpose. In no case shall ECOSTRAD LTD be liable under any legal theory, including but not limited to contract or strict liability, for any direct, indirect special, incidental or consequential damages resulting from product use. -
Page 2: Important Safety Precautions
Switches and other controls cannot be touched by a person in a bath or shower. If in doubt, do not install. Ecostrad Ltd shall not be liable for any loss, damage or injury caused or resulting from inadequate fitting or incorrect placement of heaters close to water sources. -
Page 3: Electrical Information
(for example warehouses where workers are active or wear warm clothing). For permanent installation (i.e. not using stand), Ecostrad Tuscany must be located in a position to allow proper and efficient that ensures parts touched accidentally. The recommended installation height of the Tuscany is 2.4m to 3.5m (95”-138”) from the IMPORTANT: floor. -
Page 4: Installation
Under no circumstances is the Tuscany to be installed at less than 1.8m (71”) from the floor. Consideration should be given to any temporary or occasional additions such as stages or platforms and adjusted accordingly. For outdoor use, or other areas with air movement/wind the directional Infrared spread may reduce by 1/3 to 1/2. Wall/ceiling mount swivel brackets are provided with the heater which has been specifically designed to allow this product to be fitted to a wall or ceiling with adequate clearances at the back of the unit. -
Page 5: Troubleshooting
After cleaning, it is advisable to warm the heater for 10 – 20 minutes to dry the unit and prevent staining. The lamp used in the Ecostrad Tuscany is Ultra long life (10,000 hours). Changing the lamp should only be carried out by suitably qualified personnel using the instructions available on request.
Need help?
Do you have a question about the Tuscany EsS-HC-25 and is the answer not in the manual?
Questions and answers