Chapter 6 - Bell 206L4 Maintenance Manual

5-19. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 4 (CONT)
DATA REFERENCE
Chapter 11
Chapter 53
Chapter 28
Chapter 96
Chapter 6 and
Chapter 53
Applicable Service
Instruction
Chapter 53
Chapter 96
Chapter 53
ECCN EAR99
PROGRESSIVE INSPECTIONS
INSPECTION TASK DESCRIPTION
ZONE 9 — AFT FUSELAGE
PLACARDS AND MARKINGS
1. Examine the placards, decals and markings. Make sure
they are readable, correctly applied and in agreement with the
applicable configuration of your helicopter.
FUSELAGE (EXTERIOR)
1. Examine aft fuselage for dents, cracks, corrosion,
delamination, loose or missing rivets and condition.
2. Examine aft fuselage for indications of fuel or oil leaks.
3. Examine the fuel cap for condition and security.
4. Examine the grounding plug for condition.
5. Examine all fuselage drains for condition and freedom from
obstructions.
6. Examine heater and/or air conditioning inlets and outlets
for cleanliness and absence of obstructions, (if installed).
7. Examine baggage compartment door, seal, and latches for
operation, condition, and security.
8. Verify operation of the baggage door ajar caution light, (if
installed).
FUSELAGE (INTERIOR)
1. Examine baggage compartment for condition.
2. Gain access to inside of aft fuselage through access
panels in baggage compartment and access panel located on
the aft right hand fuselage:
a. Examine access panels and fasteners for condition.
b. Examine under engine pan for fuel, oil or water leaks.
BHT-206L4-MM-1
INITIAL
MECH
25 FEB 2011 Rev. 13
OTHER
5-00-00
Page 41