Chapter 6 - Bell 206L4 Maintenance Manual

5-30. 1200-HOUR INSPECTION (CONT)
DATA REFERENCE
BHT-206L-CR&O

Chapter 67

ECCN EAR99
SCHEDULED INSPECTIONS
INSPECTION TASK DESCRIPTION
b. If nylatron sleeves were worn through, exposing bare
surface of control tube, and control tube is worn not in excess of
0.004 inch (0.10 mm) on one side only, replace worn nylatron
sleeves.
c. If control tube is worn greater than 0.004 inch
(0.10 mm) at any point, or if wear extends more than half way
around tube regardless of depth, scrap control tube.
d. Inspect tube for corrosion. Pay particular attention to
bond line at nylatron sleeves.
3. Install and connect control tubes, and bellcrank in tailbone.
Reinstall tail rotor gearbox fairing and access panel on right side
of aft fuselage.
BHT-206L4-MM-1
MECH
25 FEB 2011 Rev. 13
INITIAL
OTHER
5-00-00
Page 97/98