Table of Contents
Advertisement
5-55.
ENGINE COMPRESSOR STALL OR SURGE (CONT)
DATA REFERENCE
Chapter 63
Chapter 65
ECCN EAR99
CONDITIONAL INSPECTIONS
INSPECTION TASK DESCRIPTION
Removal or dismantling of components is not
required while performing the following inspection.
PART II: INSPECTION FOR COMPRESSOR STALL OR
SURGE WITHOUT NOTICEABLE YAW
DRIVE SYSTEM
1.
Examine the chip detectors of the transmission, freewheel
assembly, and the tail rotor gearbox. If the chip detector shows
signs of metal particles, perform a serviceability check.
Components that fail the serviceability check shall be removed.
Make an entry on the applicable components Historical Service
Record and attach a tag and write, "THIS COMPONENT WAS
REMOVED FROM SERVICE BECAUSE OF A COMPRESSOR
STALL/SURGE". Send the component to a Bell Helicopter
Textron approved facility for overhaul.
2.
Examine the tail rotor driveshafts for condition and security
of attachment.
3.
Examine the tail rotor disc pack couplings for cracks or
gapping greater than 0.015 inch (0.38 mm).
4.
Examine the tail rotor steel driveshaft and adapters for
structural failure or distortion exceeding specified limits.
5.
Examine the bond lines on all bonded tail rotor driveshaft
adapters (if installed) for any evidence of cracks and voids.
6.
If any defect is detected in step 2 through step 5, all
bonded tail rotor driveshafts shall be considered unserviceable
and discarded.
7.
Examine the tail rotor driveshaft segments having riveted
adapters (if installed) for condition.
8.
Examine the oil cooler shaft and forward short shaft for
condition.
9.
Examine the engine-to-transmission main driveshaft for
condition.
NOTE
25 FEB 2011 Rev. 13
BHT-206L4-MM-1
INITIAL
MECH OTHER
5-00-00
Page 169
Hide quick links:
Advertisement
Chapters
Table of Contents
