GE MOTOR MANAGER 2 Instruction Manual page 146

8.4 USING MM2PC
4. Program the displayed values with the pull-down menu beside each Graph Description. Change
the Color, Style, Width, Group#, and Spline selection as desired.
5. Select the same Group# for all parameters to be scaled together.
6. Select Save to Store the Graph Attributes then click OK to close the window.
7. In the Trending Window, select the Sample Rate, click the checkboxes of the values to be dis-
played, and click RUN to begin the trending sampling.
8. The Trending File Setup button can be used to write the graph data to a file in a standard spread-
sheet format. Ensure that the Write Trended Data to File box is checked and that the Sample
Rate is at a minimum of 5 seconds. Select the file capacity limit to the amount of memory avail-
able for trended data.
MODE SELECT
Click on these buttons to view
Cursor Line 1, Cursor Line 2, or
Delta (difference) values for the graph
8
CHECK BOXES
Toggle the Check Box to
view the desired graphs.
8-12
®
BUTTONS
Print, Setup (to edit Graph Attributes)
Zoom In, Zoom Out
Figure 8–4: TRENDING VIEW
MM2 Motor Manager 2
LEVEL
Displays the value of the graph
at the active Cursor Line
CURSOR LINES
To move lines, move mouse pointer
over the cursor line. Click and hold the
left mouse button and drag the cursor
line to the new location
®
8 MM2PC SOFTWARE
WAVEFORM
The trended data
from the MM2.
GE Power Management