Call Sign Editor; Setting Operational Frequency - XIEGU G90 Operation Manual

Call Sign Editor

This G90/S can set your call sign to be displayed on the startup screen.
1. Apply a long press to the [VM] button to enter the text editor.
2. The bottom of the screen is the character selection area. Rotate the main
tuning knob to select the desired character. Press the main tuning knob in to
select the character;
3. Press the [NB] button (underneath BACK on the screen) to delete the last
character; press the [VM] button (underneath QUIT on the screen) to exit the
editor interface; press the [PRE] button (underneath SAVE on the screen) to
save and exit the editor interface.
These LCD screen labels will be close to, but not exactly aligned with the
buttons below the screen.
4. When the radio is re-started, your callsign will be displayed on the screen.
Main knob

Setting Operational Frequency.

There are three methods to set the frequency of G90/S. You may use the large
main knob, the multi-function knob or the keypad buttons on the hand
microphone.
1. Set frequency by using main knob
Momentarily press the main knob to select 100Hz, 1kHz, 10kHz or 100KHz
steps. The selected range step position in the display will be graphic reversed.
Rotate the main knob to set the frequency required using the currently selected
step.
2. Set frequency by using the multi-function hand microphone
Press the white [F-INP ENT] button on the hand microphone. The G90/S will
now be in frequency setting mode. The cursor will be blinking in the first column
on the left of frequency display.
24