Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for XIEGU G1M
Summary of Contents for XIEGU G1M
- Page 1 XIEGU Four bands HF transceiver User manual V1.0.0-(Beta) XIEGU Tech...
- Page 2 Catalogue General parameters Panel Introduction Operation...
- Page 3 Parameters Receiving frequency：0.5～30MHz（Continuous） Transmitting frequency： 3.5～4.0MHz 7.0～7.3MHz 14.0～14.35MHz 21.0～21.45MHz Operating mode： SSB/CW Receiving sensitivity： 0.35uV @12dB SINAD Receiving dynamics： 90dB Transmit power： 5W @13.8V DC Spurious suppression： ≥45dB ±2.5ppm （30 minutes after turning on the power） Frequency stability： Audio output power： 0.5W Operating Voltage：...
-
Page 4: Front Panel
Front Panel Screen 显示屏 开关/音量 Switch/volume 主旋钮 Main knob 手咪插口 Mic socket 多功能按键 Multi-function button... -
Page 5: Rear Panel
Rear panel ④ ③ ⑤ ② ⑥ ① ⑦ ① Power socket ⑤ ACC Interface ② External speaker socket ⑥Antenna interface ③ CW Key Interface ⑦Ground terminal ④ Computer communication interface... - Page 6 Operation Page one menu TS+: The frequency stepping is shifted to the left by one； MD: Mode selection. After pressing, they are respectively LSB-USB-CW； A/B: switching of voltage controlled oscillators VFOA and VFOB； A=B: Set VFOB to the same VFOA setting； ...
- Page 7 Page two menu V/M: frequency mode and channel mode switching; MC: Clearing the current channel storage in channel mode； V>M: When the current channel is empty, the currently frequency, mode other information are stored in the current channel；...
- Page 8 Page three menu PRE: The switch of the preamplifier. When the preamplifier is turned on, the small white point before the PRE in the upper left corner of the screen will be displayed, indicating that the preamplifier is turned on; when the preamplifier is turned off, the white point becomes hollow.
- Page 9 Page four menu RIT： RIT: After the frequency fine adjustment is turned on, rotate the frequency knob to fine-tune the frequency. When the RIT is turned off, the fine-tuning data is automatically cleared； MUT: system prompt tone mute switch； ...
- Page 10 Project menu description Note: Please do not change the settings of the project menu at will, so as not to cause the rig to work abnormally! Press and hold the "LK/SYS" button for 2s to enter the project menu setting interface. ...
- Page 11 05.CW TONE: CW mode side tone tone setting; 06.CW TDLY: CW transmission delay setting; 07. KYR SPD: Automatic telegraph key transmission rate setting; 08.TXP TIM: Long-term protection time setting, in seconds; 09.BRITNES: screen brightness setting; 10.CNTRST: screen contrast setting; 11.FBND TX: Non-amateur frequency prohibition of launch settings; 12.DDS CLK: DDS clock setting;...
- Page 12 Copyright 2018 Chongqing Xiegu Technology Co., Ltd. reserves all rights to this manual, and reproduction of any part of this manual is prohibited without permission. ------------------------------------------------------------------------------------------------ V1.0.0（Beta） 1010160206-C...