Channel Memories - XIEGU G90 Operation Manual

Channel storage MW - Clearing a Memory Channel
Channel storage：
In the VFO mode, adjust the required frequency, mode and other parameters;
1.
Press the [ MW/MC ] button momentarily and the CH 00 (channel number) character will appear on the screen flashing. Rotate
2.
the main knob to select an empty channel. A character E will appear after the channel number, indicating that the channel is
empty and can be used.
Press the [ MW/MC ] button again to save the current set frequency information to the selected channel.
3.
Using Memory Channels:
Press the [VM] button on the panel in VFO mode to enter channel memory mode; (alternates VFO/Mem)
1、
Rotate the main knob to switch to select memory channels. (or use mic up/down buttons)
2、
Clearing a memory channel:
1. In channel mode, press [FUNC] then [MW/MC], at which point the channel number starts to flash;
2. Turn the main knob to adjust to the channel you want to clear. Press the [MW/MC] button again to clear the selected channel.
LCD Display
29