Setting Operation Frequency - XIEGU G90 Operation Manual

Set the operating frequency
There are two ways to set the G90 operating
frequency, which is to use the main knob and multi-
function handle to set the frequency.。
Operating method：
1、 Set the frequency using the main knob

Short press the main knob, select 100Hz,
1kHz, 10kHz Stepper.

Rotate the main knob to set the frequency
of the current step.
2、Set the frequency using the multifunction handle

Press the [F-INP ENT] button on the handle, G90 enter the frequency setting state, the cursor will blink in the first
position on the left side of the frequency display bit;

Enter the frequency values you want to set, and then press the [F-INP ENT] button again to complete the
frequency setting.
For example, set the current frequency to 14.09000MHz, and the key order is as follows:
1. First press the [F-INP ENT] button;
2. Press the 1 4
3. Press the [F-INP ENT] button again, complete the setup.
Operating
. 0 9 0 0 0 number key in sequence;
Main Knob
19