Powering Up The Device - Multitech MultiConnect Conduit MTCDT Hardware Manual

SETTING UP AND CONFIGURING THE DEVICE

Powering Up the device

CAUTION: Use only the power cord provided with the device. Using any other power cord voids the warranty
and can damage the device.
To power up the device:
1. Install the desired MultiTech accessory card or cards into the slots at the back of the device. Refer to the
appropriate installation documentation for the accessory card.
2. Connect the power cord to an outlet or power strip and to the power adapter.
3. Connect the power adapter to the barrel jack on the back panel of the device.
4. Verify power.
5. Connect the device to the controlling device through the Ethernet connector or the USB connector on the
back panel.
28
The Power LED comes on immediately after power is applied.
The device takes a short time to boot up when you apply power.
® TM
MultiConnect Conduit Hardware Guide