Retesting Requirements; Radio Frequency Interference; Installation; Connecting The Vp8800 - ID Tech VIVOpay VP8800 User Manual

Table of Contents

Advertisement

Can the Cashier View the PIN: While one person stands at the VP8800 with their hand
positioned to enter the PIN, the other tester should stand behind the counter and try to observe
the PIN keypad. The second tester should move around a little to see if there is a position where
they can observe PIN entry.
Can the Video Camera View the PIN: While one person stands at the VP8800 with their hand
positioned to enter the PIN, the other tester should observe what is being recorded by any video
camera with a view of the VP8800. This may require playing back a recording to see if PIN entry
is visible. If the video camera is moveable, the second person should move the video camera to
determine if there is a position where PIN entry can be observed.

4.3.1. Retesting Requirements

If PIN entry on the VP8800 is observable in any of the above tests, reposition the VP8800 and
completely retest all locations to verify that PIN entry is not visible. Consider placing a display to block
observation from that position.
Repositioning the VP8800 to block observance of PIN entry at one location may expose PIN entry to
observation at another location. PCI requires repositioning the VP8800 and retesting until PIN entry is
secure from observation.

4.4. Radio Frequency Interference

To perform contactless transactions, the VP8800 uses a radio frequency antenna. The range (reading
distance) and performance of the reader can be affected by other radio frequency emitters and
proximity to metal.
For best performance, adhere to the following guidelines:
1. Do not position the VP8800 closer than 1 foot (30 cm) to other RF-emitting devices. Some
environments may require greater separation distances.
2. Avoid placing the VP8800 near large metal objects.
3. Do not position the VP8800 near radio transmitters.

4.5. Installation

This section describes how to install the VP8800. The basic steps are:
Connect to power and POS
Mount if required
Test the installation

4.6. Connecting the VP8800

4.6.1. Accessing the Connectors

The VP8800 connectors are beneath a cover on the bottom of the reader.
Page | 8

Advertisement

Table of Contents
loading

Table of Contents