Redman Power Chair CHIEF 107 SERIES Owner's/Operator's Manual page 43

Refer to section 5 for a detailed description of Diagnostic screen and procedure. Refer to Chapter 5
Diagnostics for a complete description of the Trip Texts.
7 Getting Ready to Drive
7 Operate the On/Off switch. The screen will go through an initializing process then
show the base screen as follows. In the case on an LED Joystick Module the battery
gauge will illuminate.
8 Check that the Speed Setting is at a level that suits you.
9 Push the joystick to control the speed and direction of the wheelchair.
If you push the joystick before or just after you switch the control system on,
the screen will flash the joystick displaced screen. You must release and center the
joystick to resume normal operation. If you do not release the joystick within five
seconds the wheelchair will not be able to move, even if you release the joystick and
push it again. The screen will display the diagnostic screen at this time. You can
reset this condition by switching the control system off and on again.
38