Redman Power Chair CHIEF 107 SERIES Owner's/Operator's Manual page 36

• Make sure that all connectors on the listed Module and the wheelchair are mated securely.
• Check the condition of the battery.
• Note the Trip Text description, and take the required action.
• Switch on the control system again and try to drive the wheelchair. If the safety circuits operate
again, switch off and do not try to use the wheelchair. Contact your service agent.
Example:
Identified Module Power Module.
Trip Text Low Battery
Trip Code 2C00
This means the battery needs charging or there is a bad connection to the battery.
- Check the connections to the battery. If the connections are good, try charging the battery.
.3 Locking the Control System
The Control System can be locked in one of two ways. Either using a button sequence on the keypad or with a
physical Key. How the Control System is locked depends on how the wheelchair manufacturer has programmed
the system.
.3.1 Keypad Locking
To lock the wheelchair using the keypad;
• While the control system is switched on, depress and hold the On/Off button.
• After 1 second the control system will beep. Now release the On/Off button
• Deflect the joystick forwards until the control system beeps.
• Deflect the joystick in reverse until the control system beeps.
• Release the joystick, there will be a long beep.
• The wheelchair is now locked.
The following screen will be displayed, the next time the Control System is switched on.
If an LED Joystick Module is fitted the Speed Indicator LEDs will ripple
from left to right. Refer to Chapter 4.
31