Redman Power Chair CHIEF 107 SERIES Owner's/Operator's Manual page 42

6.4.4 Cross & Tick
These symbols will be displayed during configuration procedures.
6.4.5 E-stop
6.4.6 Joystick Displaced
6.4.7 Control System Locked
6.4.8 Diagnostic Screen
When the control system safety circuits have operated and the control system has been prevented from
moving the wheelchair a diagnostics screen will be displayed.
This indicates a system trip, i.e. the R-net has detected a problem somewhere in the wheelchair's
electrical system.
Process completed correctly.
Process not completed correctly.
If the External Profile Switch is activated during drive, or actuator operation, this symbol
will be displayed.
If you operate the Joystick before or just after you switch the control system on, the
screen will flash the joystick displaced screen.
You must release and center the Joystick to resume normal operation. If you do not
release the Joystick within five seconds the wheelchair will not be able to move, even
if you release the Joystick and operate it again. The screen will display a diagnostic
screen at this time. You can reset this condition by switching the control system off
and on again.
The Control System can be locked in one of two ways. Either using a sequence of
deflections and presses with a Joystick or with a physical Key. How the Control System
is locked depends on how the wheelchair manufacturer has programmed it.
Refer to Section 5 for a detailed description of the Locking and Unlocking
procedures.
37