5.1.7 Restart
5.1.8 Fault
The control system can detect a wide variety of errors. When the system has detected an
error that is not severe enough to cause the system to trip, then this symbol will be
displayed.
5.1.9 Motor Temperature
5.1.10 Control System Temperature
5.1.11 Timer
5.1.12 E-Stop
5.1.13 Bluetooth
When the control system requires a reboot; for example, after a module
re-configuration, this symbol will be flashed.
This symbol is displayed when the control system has intentionally reduced the power
to the motors, in order to protect them against heat damage.
This symbol is displayed when the control system has intentionally reduced its
own power, in order to protect itself against heat damage.
This symbol is displayed when the control system is changing between different
states. An example would be entering into Programming Mode. The symbol is
animated to show the sands falling.
If the control system is programmed for latched drive or actuator operation, then it is
normal for an Emergency Stop Switch to be connected into the External Profile
Switch Jack.
If the Emergency Stop Switch is operated or disconnected, this symbol will be
displayed.
When Bluetooth Mode is entered the screen will display the following icon.
29