R-Net © General Information - Redman Power Chair CHIEF 107 SERIES Owner's/Operator's Manual

R-NET TECHNICAL MANUAL- OPERATION PG
1 Introduction
The relevant contents of this chapter should be included in the wheelchair's operating guide. Further
copies are available from PGDT in either written or disk (Adobe PDF) format. Copies should not be
made without the express permission of PG Drives Technology.
The operation of the R-net varies dependent on programming. This chapter covers all types of
operation. It is the responsibility of the wheelchair manufacturer to ensure that only the relevant
sections of this chapter are included in the wheelchair's operating manual.
The operation of the R-net wheelchair control system is simple and easy to understand. The control
system incorporates state-of- the-art electronics, the result of many years of research, to provide
you with ease of use and a very high level of safety. In common with other electronic
equipment, correct handling and operation of the unit will ensure maximum reliability.
Please read this chapter carefully - it will help you to keep your wheelchair reliable and safe.
2
General
An R-net control system comprises a minimum of two modules - Joystick Module and Power
Module. Because of the modular design, the depth of the control system can be greatly increased.
The following diagram shows the basic set-up.
Handling
2.1
Avoid knocking your control system and especially the joystick. Be careful not to strike obstacles with
the control system or joystick when you drive. Never drop the control system.
When transporting your wheelchair, make sure that the control system is well protected. Avoid
damage to cables.
Operating Conditions
2.2
Your control system uses industrial-grade components throughout, ensuring reliable operation in a wide
range of conditions. However, you will improve the reliability of the control system if you keep
exposure to extreme conditions to a minimum.
DRIVES TECHNOLOGY
22