Body Positioning; Joystick Wiring - Redman Power Chair CHIEF 107 SERIES Owner's/Operator's Manual

Body Positioning Troubleshooting
Body positioning control components are located under the power chair. (In the event of a motor
power failure, check to make sure connections are tight). The ISM (Intelligent Seating Mechanism)
controls the actuators for positioning of your chair. If the chair will not stand or positioning systems
fail, try a hard reset by disconnecting the main power at the circuit breaker. Leave the circuit breaker
pulled out for five minutes before pushing back in (reference Troubleshooting- Hard Reset). If the
component is not functioning and
the chair will not move to a standing
position to access the ISM, the seat
pan may be removed for easier
access.
Use Figure 15 to the right to reference
the positioning of the cables to your
control system.
Figure 15

Joystick Wiring

The following pictures are intended to
show the locations of a loose-fitting cable
that could lead to error messages or a
malfunction. Use Figure 16 to reference the
positioning of the joystick cable. This cable
can be followed from the joystick down to
the ISM. If necessary, also check the
connection of the second cable from the
ISM to the power module as shown in
Figure 17.
Figure 16
Figure 17
15