Table of Contents
Advertisement
7.
USB 2.0 connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
IMBM-H61A
IMBM-H61A USB 2.0 connectors
CAUTION! Never connect a 1394 cable to the USB connectors. Doing so will
damage the motherboard!
NOTE: The USB module cable is purchased separately.
8.
SPI programming connector (10-pin SPI)
Use this connector to flash BIOS SPI ROM.
IMBM-H61A
IMBM-H61A SPI programming connector
2-20
USB56
USB78
PIN 1
PIN 1
SPI
(NC)
(NC)
SPI_MOSI
SPI_MISO
SPI_CLK
SPI_CS#
GND
+V3.3SPI
PIN 1
IMBM-H61A
Advertisement
Table of Contents
