Setup Instructions - Polygroup SUMMER WAVES ST1100 Owner's Manual

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING:
CLIMBING HAZZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTRATION SYSTEM TO GAIN ACCESS TO THE POOL.
1. Set up the pool by following all the instructions that came with the
pool. Do not fill water until the Filter Pump is properly
installed. Locate the Outlet and Inlet openings on the pool wall.
Outlet
Inlet
3. Install the Return Fitting 26
27
26
21
Inside Pool Wall
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.

SETUP INSTRUCTIONS

on the Inlet opening of the pool.
24
MST. Extended operating days and hours during peak season requirements.
2. Install the Suction Fitting
Outside Pool Wall
4. Snap the Pump
Outside Pool Wall
OWNER'S MANUAL
22 on the outlet opening of the pool.
21
23
24
Inside Pool Wall
on to the Sand Tank Base
1 7
17
22
1
1
9