Setup Instructions - Polygroup Summer Waves Skimmerplus SFX1500+ Owner's Manual

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING:
CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
1. Set up the pool by following all the instructions that came with the pool. Do not
fill with water until the Filter Pump is properly installed. Locate the
Skimmer and Inlet openings on the pool wall.
Skimmer opening
Inlet
opening
3. Remove the Seal Ring by turning it counterclockwise. Make sure to keep
the Skimmer Gasket in the proper position. (see image below)
5. Assemble the wall fitting parts according to the following schematic.
Inside Pool Wall
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.

SETUP INSTRUCTIONS

Make sure the key
feature is facing the
correct location.
Make sure there is no gap here.
Make sure the hose clamp
is positioned properly over
the hose and o-ring to
ensure proper seal.
MST. Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
2. Remove the Skimmer Top Cover
inside.
4. Place the threaded intake of the skimmer through the round skimmer
opening in the pool liner and screw the seal ring
Inside Pool Wall
6. Final assembly must look like the following schematic.
canister
It is recommended to point the diverter
down and away from the suction or water
intake for optimum pool circulation.
5 and take out the parts contained
5
tightly into place.
Make sure the two rubber keyways
are properly located before installation.
Make sure the pool liner is
on this round surface and
does not fall into the thread
slots as this may cause leaking.
thread slots
Outside Pool Wall
Inside Pool Wall
9