Polygroup SUMMER WAVES Series Owner's Manual

Polygroup SUMMER WAVES Series Owner's Manual

Sand filter pump for above ground swimming pools
Hide thumbs Also See for SUMMER WAVES Series:

Advertisement

SUMMER WAVES
SAND FILTER PUMP
READ, AND KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Should you encounter a problem with your Polygroup
Polygroup
. Prior to contacting Customer Service, please first review the Troubleshooting Guide in the Installation Manual, or review the FAQ at www.Polygroup.com.
®
Please review setup instruction videos on www.Polygroup.com/video. If you are still unable to correct the problem, please contact Polygroup
Appendix . Have the product type and your purchase receipt ready. Our Customer Service Representative will assist you in resolving the problem. You may be asked
to return all or part of the product for inspection and/or repair. Do not return any product to Polygroup
Polygroup
Limited (Macao Commercial Offshore), (hereinafter "Polygroup
®
material and workmanship for 180 days from the date of purchase. Original Purchaser must retain proof of such purchase in the form of an original store sales
receipt and must produce such upon request by Polygroup
This Limited Warranty applies only to the original purchaser of the product and is limited solely to the repair or replacement of the product, to be decided in
Polygroup
's sole discretion. Consequential damages, including claims for loss of water, pool chemicals, damage, or labor are not covered under this Limited
®
Warranty.
This Warranty will be declared invalid should the Purchaser modify or repair the product themselves or by unauthorized persons; use non-Polygroup
accessories with the product; use the product in contravention of the manufacturer's Instructions; use improper voltage; abuse the product in any way; or through
accident or negligence. Normal wear-and-tear is not covered under this Warranty, nor are acts of God outside the control of Polygroup
IN NO EVENT SHALL Polygroup
PARTY FOR DIRECT OR CONSEQUENTIAL DAMAGES. Some states or countries, or others jurisdictions do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.
®
Trademarks used in some countries of the world under license from Polygroup
TM
Unit J, 10
Floor, Macau Square, Av do Infante D.Henrique, No.43-53A, Macau. Tel:(853) 2875 2606 Distributed in European Union
th
by Germany Sales & Service Office., RMS GmbH, Besselstr.25, 68219 Mannheim. Tel:0621 8455 210 Service@rms-gruppe.de
FOR ABOVE GROUND SWIMMING POOLS
ST1100 (10") / ST1600 (12") models
Product, please do not return the product to the place of purchase. All Warranty claims must be made directly to
®
LIMITED WARRANTY
or its designated agents. Warranty claims cannot be processed without a valid proof of purchase.
®
, THEIR AUTHORIZED AGENTS, RELATED ENTITIES, OR EMPLOYEES BE LIABLE TO THE BUYER OR ANY OTHER
®
OWNER'S MANUAL
without a Return Authorization number.
®
") warrants to the original purchaser only, the Sand Filter Pump against defects in
®
LIMITED (MACAO COMMERCIAL OFFSHORE).,
®
®
Customer Service at
®
parts or
®
.
®

Advertisement

Table of Contents
loading

Summary of Contents for Polygroup SUMMER WAVES Series

  • Page 1 ® Polygroup . Prior to contacting Customer Service, please first review the Troubleshooting Guide in the Installation Manual, or review the FAQ at www.Polygroup.com. ® Please review setup instruction videos on www.Polygroup.com/video. If you are still unable to correct the problem, please contact Polygroup Customer Service at ®...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Warnings ................................. 3 ~ 6 Save These Instructions & Sand Pump Power Information & Part List ............7 ~ 8 Setup Instructions & Operation Instruction ...................... 9 ~ 13 Operating Instructions ............................. 14 Pump Motor Protection & Pump Maintenance ....................15 Pool Water Care .............................
  • Page 3: Warnings

    OWNER’S MANUAL IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: READ AND FOLLOW ALL INSTRUCTIONS Keep for Future Reference. Failure to follow these warnings and instructions can result in serious injury or death to users, especially children. DANGER WARNING NO DIVING!
  • Page 4: Warnings

    installed pools. Improper use may lead to overheating and permanent damage of the product. 8. WARNING! To avoid the risk of electric shock, always be aware of damaged cords. 9. WARNING! The power cord cannot be replaced. If the cord is damaged, the the filter pump should be disposed of. 10.
  • Page 5 Turn on the filter pump system for at least six hours per day. Clean and replace Sand frequently. Replace only with genuine Polygroup / Summer Waves Brand Sand tank.
  • Page 6 9. Do not install on a deck or other surface at, above, or slightly below the top rail of the pool. 10. Do not use the filter pump during severe weather conditions, i.e. electrical storms, tornadoes, etc. 11. Be aware of overhead power lines when vacuuming your pool or using a telescoping pole. 12.
  • Page 7: Save These Instructions & Sand Pump Power Information & Part List

    5. All electrical components shall be installed in accordance with Article 680 of the National Electrical Code (NEC) “Swimming Pools, Fountains and Similar Installations” or its latest approved edition. 6. The Pump are manufactured by Polygroup and ETL control number 4000608 and 4006317 - double insulated and grounded - 220-240 V.A.C - 50Hz.
  • Page 9: Setup Instructions & Operation Instruction

    OWNER’S MANUAL SETUP INSTRUCTIONS Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts. WARNING: POSITION THIS PRODUCT AWAY FROM THE POOL, SO AS TO PREVENT CHILDREN FROM CLIMBING ON IT AND ACCESSING THE POOL. 1.
  • Page 10 5. Put the Center Pipe inside the Sand Tank . Let the 6. Attach the Sand Guard to the top opening of the Center Center Pipe seats at the center of the Sand Tank Pipe 7. Fill the tank with #20 silica sand. You can purchase the sand from your local home improvement or building material store. Slowly pour sand into the Sand Tank until the sand level is between the Min and Max marks on the Center Pipe Sand...
  • Page 11 OWNER’S MANUAL 9. Place the 6-Port Valve to the Sand Tank . Make sure the 6-Port 8. Remove the Sand Guard and save for future use. Valve O-Ring is present at the bottom flange of the 6-Port Valve . Make sure the center tube extending from the valve fits securely with the Center Pipe .
  • Page 12 13. Hold the CAM-HANDLE with one hand and start turning in 12. Turn the CAM-HANDLE so that the CAM-BOLT is inserted clockwise direction. into the slot on the other jaw. CAM-HANDLE CAM-BOLT CAM-HANDLE 14. Continue to turn the CAM-HANDLE to tighten the jaw until no 15.
  • Page 13 OWNER’S MANUAL 17. The sand filter pump is now fully assembled. Connect the sand filter 16. Connect the Short hose between the Pump Outlet pump to the pool with the Long Hoses supplied with the pump. and the 6-Port Valve Inlet. Tighten the Hose Clamp Connect the pool Outlet to the Pump Inlet.
  • Page 14: Operating Instructions

    OPERATING INSTRUCTIONS 1. Make sure all the Hoses are secured to the fittings on the pump and pool. 2. Always press down the 6-port Valve Handle before switching position. Inlet port 3. Always turn off the pump power when switching position. 4.
  • Page 15: Pump Motor Protection & Pump Maintenance

    5. Check filter pump, hoses, fitting for leaks. If a leak is found, see below Section of “TROUBLE SHOOTING GUIDE”. 6. Check seams in pool periodically. Minor repairs may be made with the repair patch kit (supplied with pool). Additional patches are available from Polygroup or your ®...
  • Page 16: Troubleshooting Guide

    TROUBLESHOOTING GUIDE WARNING: UNPLUG THE POWER CORD BEFORE TROUBLESHOOTING THE FILTER PUMP. PROBLEM CAUSE SOLUTION A The motor is not plugged in. A Power cord must be plugged into a grounded power outlet. Or not activated B Low voltage B Check the line voltage, it must be in the range of 105 to 125V. 1 Pump motor C Plug and/or circuit C Reset the plug and/or circuit breaker.
  • Page 17: Replacement Parts Ordering Information

    OWNER’S MANUAL REPLACEMENT PARTS ORDERING INFORMATION ST1100 ST1600 Description Key# PART # PART # Sand Tank Base P58PP2884A09 P58PP1782E09 Sand Tank P58000001W05 P58000000W05 Drain Valve Cap P58PF0800W05 P58PF0800W05 6-Port valve Drain Outlet Window P58PF8960C01 P58PF8960C01 Center Pipe P586402001W1 P586402000W1 Sand Guard P58PF8891P01 P58PF8891P01 Clamp...
  • Page 18: Customer Services Contact

    Telephone: 0800788298 Italy Address: 12 Eldon Way Hockley Essex Telephone: 49(0) 6218455210  Germany Address: Germany Sales & Service Office RMS GmbH Besselstr.25, 68219 Mannheim Service@rms-gruppe.de Australia and Islands Telephone: 1800-451-190 https://polygroup.zendesk.com/hc/en-us For answers to most frequently asked questions, please visit...

This manual is also suitable for:

Summer waves st1100Summer waves st1600

Table of Contents