Cardinal 190 Series Installation, Technical And Operation Manual page 80

Model 190 Installation, Technical and Operation
Page 70
Prty= (Optional Serial Interface Parity Setting)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then
press the TARE  key to save it. Allowable settings are:
0 = No Parity with 8 data bits
1 = Odd Parity with 7 data bits
2 = Even Parity with 7 data bits
Cont2= (Continuous Output on Optional Serial Interface)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then
press the TARE  key to save it.
YES = Continuous Output on Optional Serial Interface
no = No Continuous Output on Optional Serial Interface
IMPORTANT! The setting for the type= are only applied
when the opt= parameter is set to 1 and Cont2=
parameter is set to YES.
tyPE= (Continuous Output Format)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then
press the TARE  key to save it. Allowable settings are:
0 = Continuous Output uses SMA format
1 = Continuous Output uses Cardinal Scoreboard format
NOTE: Refer to the CONT1= Continuous Output on Serial
Interface, tYPE= parameter for description of output formats.
8400-M022-O1 Rev J