Setup - Cardinal 190 Series Installation, Technical And Operation Manual

Model 190 Installation, Technical and Operation

15.3 Setup

Page 150
Enter SETUP and proceed to the Options Setup.
option
With option displayed, press the TARE  key. The display will
change to show opt=. Proceed to the opt= parameter.
opt?
With opt? displayed, press the TARE  key. The display will
change to no. Press the Fn/ key to toggle to yes and then
press the TARE  key. The display will change to opt=.
Proceed to the opt= parameter. Otherwise, to skip the Options
Setup, press the TARE  key to advance to the fUnC?. prompt.
oPt= (Option)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/▲ key to toggle to a new setting and then
press the TARE  key to save it. Allowable values are:
0 = No Option Card Installed
1 = Serial Interface, Ethernet, WiFi or USB Option Card
Installed
2 = not applicable
3 = not applicable
4 = Digital to Analog Converter Option Card Installed
bAUd= (Optional Serial Interface Baud Rate)
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new baud rate for the
serial ports and then press the TARE  key to save it. Allowable
settings are:
12 = 1200 Baud
96 = 9600 Baud
76 = 76.8k Baud
24 = 2400 Baud
19 = 19.2k Baud
48 = 4800 Baud
38 = 38.4k Baud
8400-M022-O1 Rev J