Cardinal 190 Series Installation, Technical And Operation Manual page 187

Prty= (Option Card Parity Setting)
Cont2= (Continuous Output on Option Card)
tyPE= (Continuous Output Format)
8400-M022-O1 Rev J
Press the TARE  key to show the current setting. If the setting displayed
is 0, press the TARE  key again to save it. Otherwise, use the Fn/ key
to toggle the parity setting to 0 (No Parity with 8 data bits) and then press
the TARE  key to save it.
NOTE: The default parity is 0 (No Parity with 8 data bits) and should not
be changed.
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then press
the TARE  key to save it.
YES = Continuous Output on Optional Serial Interface
no = No Continuous Output on Optional Serial Interface
IMPORTANT! The setting for the type= are only applied when
the opt= parameter is set to 1 and Cont2= parameter is set to
YES.
Press the TARE  key to show the current setting. If the setting
displayed is acceptable, press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and then press
the TARE  key to save it. Allowable settings are:
0 = Continuous Output uses SMA format
1 = Continuous Output uses Cardinal Scoreboard format
2 = Continuous Output uses Cardinal SB500 with traffic control format
NOTE: Continuous Output tYPE= settings are for the
selection of the format only. A scoreboard cannot be
connected directly to the 190-USB.
NOTE: Refer to the CONT1= Continuous Output on Serial Interface,
tYPE= parameter section 4.8.1 and 4.8.2 for description of output
formats 0 and 1.
Model 190 Installation, Technical and Operation
Page 177