Auto Axle Weighing Operation - Cardinal 190 Series Installation, Technical And Operation Manual

14.4 Auto Axle Weighing Operation

14.4.1 Auto Axle Weighing Ticket Format
8400-M022-O1 Rev J
1. In the idle state the light will be green and the system will wait for a
truck to approach
2. The first axle is driven on the scale and the weight exceeds tHrS, the
threshold weight. The traffic light will turn red. The Gross weight for
that axle will be displayed.
3. After the motion on the scale stops, the printer will print the weight on
the scale and add the weight to the total accumulator. The Printd
message will be displayed on the 190 display.
4. After the SDLY (Stoplight Delay) timer runs out the light will turn green.
At this time the system is ready for the next axle, if any.
5. Repeat steps 2 through 5 for each new axle.
6. After all of the axles have been weighed and the scale weight is below
tHrS (threshold weight), the TdLY (Total Delay) time expires the total
weight will be printed and displayed on the 190 display.
DATE TIME
1 WWWWWW lb
2 WWWWWW lb
# WWWWWW lb
Total: WWWWWW lb
Where W is the weight, lb are the units.
Once all axles have been weighed and the TdLY (Total Delay) timer runs
out (ticket printed), the application is reset and is ready for the next truck.
Model 190 Installation, Technical and Operation
Page 145