Setup - Cardinal 190 Series Installation, Technical And Operation Manual

17.3 Setup

Enter SETUP and proceed to the Options Setup.
option
opt?
oPt= (Option)
bAUd= (Option Card Baud Rate)
8400-M022-O1 Rev J
With option displayed, press the TARE  key. The display will change
to show opt=. Proceed to the opt= parameter.
With opt? displayed, press the TARE  key. The display will change to
no. Press the Fn/ key to toggle to yes and then press the TARE 
key. The display will change to opt=. Proceed to the opt= parameter.
Otherwise, to skip the Options Setup, press the TARE  key to advance
to the fUnC?. prompt.
Press the TARE  key to show the current setting. If the setting displayed
is acceptable, press the TARE  key again to save it. Otherwise, use the
Fn/▲ key to toggle to a new setting and then press the TARE  key to
save it. Allowable values are:
0 = No Option Card Installed
1 = Serial Interface, Ethernet, WiFi or USB Option Card
Installed
2 = not applicable
3 = not applicable
4 = Digital to Analog Converter Option Card Installed
Press the TARE  key to show the current setting. If the setting displayed
is 96, press the TARE  key again to save it. Otherwise, use the Fn/
key to toggle the baud rate setting to 96 (9600 Baud) and then press the
TARE  key to save it.
NOTE: The default baud rate is 9600 and should not be changed.
Model 190 Installation, Technical and Operation
Page 159