Cardinal 190 Series Installation, Technical And Operation Manual page 182

Model 190 Installation, Technical and Operation
Page 172
Lo=
This is the value, in weight, which outputs zero volts (or 0 or 4 ma)
from the DAC. All weight below this target will output zero volts (or
0 or 4 ma).
Press the TARE  key to show stored value. If the setting is
acceptable, press the TARE  key again to save it. Otherwise,
using the numeric keys enter the desired weight value, and then
press the TARE  key to save it. Allowable values are: -99999 to
999999.
NOTE: The NET/GROSS key is used to change the weight sign.
For example, to input -1000 as the weight value, press 1000 NET.
Hi=
This is the value, in weight, which outputs the maximum selected
voltage and current (see oUt=). All weights above this value will
output maximum volts from the DAC.
Press the TARE  key to show the stored value. If the setting is
acceptable, press the TARE  key again to save it. Otherwise,
using the numeric keys enter the desired weight value, and then
press the TARE  key to save it. Allowable values are: 1 to
999999.
NOTE: This weight must be a positive value, up to capacity of
scale, and above the value.
oUt=
This is the maximum output value in volts (00.01 to 10.00). All
weight values equal to or greater than Hi= will output this value.
NOTE: If the scale goes oCAP (over capacity), this value is used.
Press the TARE  key to show the stored value. If the setting is
acceptable, press the TARE  key again to save it. Otherwise, using
the numeric keys enter the desired output value, and then press the
TARE  key to save it. Allowable values are: 00.01 to 10.00.
NOTE: If one of the current output ranges is selected, set oUt= to:
4-20 ma:
0-20 ma:
0-24 ma:
+1-5
10 X (max_current – 4) / 16
10 X (max_current)/20
10 X (max_current)/24
Set OUT = 5.00
8400-M022-O1 Rev J